OS client (監控畫面-HMI），OS Server(儲存及管

OS client (監控畫面-HMI），OS Server(儲存及管理資料），ES（工程師站）皆在中控樓組裝。
PLC櫃（CPU及I/O模塊）在電氣室組裝。現場Sensor直接或通過端子排跟I/O模塊連接。
控制信號先從Os client通過Ethernet通訊網傳到PLC櫃，再通過PLC已裝好的編程軟件將控制信號通過ControlNet通訊網傳到I/O模塊，該控制信號繼續從I/O模塊通過DeviceNet通訊網傳到MCC櫃的馬達保護器來控制現場設備。

Kết quả (Anh) 1:

OS client (Jian-controlled display pop-up-HMI), OS Server (儲 save and manage information material), ES (engineering Normal University Station) are in control/f team equipment.PLC 櫃 (CPU and I/O module 塊) in room TV Qi team equipment. Fully furnished apartments located Sensor directly or pass over the Terminal I/O mode 塊 footbridge.Control letter Hao first promote Os client pass over Ethernet pass 訊 Web 傳 to PLC 櫃, again pass over PLC has installation good of bian drive software pieces advises control letter Hao pass over ControlNet pass 訊 Web 傳 to I/O die 塊, this control letter Hao 繼 續 promote I/O die 塊 pass over DeviceNet pass 訊 Web 傳 to MCC 櫃 of Macedonia Prada insurance o device future control now Gatwick design equipment.

Kết quả (Anh) 2:

OS client (monitor screen -HMI), OS Server (storage and management of data), ES (Engineering Station) are assembled in the control building.
PLC cabinet (CPU and I / O modules) assembled in the electrical room. Field Sensor connected directly or via the terminal strip with the I / O modules.
Control signal start Os client communications network via Ethernet PLC cabinet reached, then the control signal through the PLC programming software has been assembled by ControlNet communications network spread I / O module, the control signal continues to spread from the I / O modules via DeviceNet communications network MCC cabinet motor protection to control field devices.

Kết quả (Anh) 3:

Client OS (-HMI), Server OS (storage and management information), ES (engineer station) are assembled in the center.
PLC cabinet (CPU and I/O module) in the electrical chamber assembly. The Sensor module is connected directly or through the terminal to the I/O module.
control signal first from the OS client through the Ethernet communication network transmitted to PLC cabinet, again through the PLC has been installed the software programming the control signal is transmitted via ControlNet communication network I / O module, the control signal to from I / O module through DeviceNet Network spread to MCC motor protector to control field devices.