按压紧接钮, 缓缓调整溢流阀手轮， 如果此时压滤机滤板已被顶紧, 则压

按压紧接钮, 缓缓调整溢流阀手轮， 如果此时压滤机滤板已被顶紧, 则压力会逐步上升, 当升至25mPa, 压力表指针接触上限时, 电机立即停止运转,当油缸压力降至18mPa, 压.力表 指针接触下限时, 电机又会自行启动, 压力又慢慢升高. 反复校验后, 固定溢流阀手轮, 让压力保持在18-25mpa 之间, 使压滤机过滤.时有足够的顶紧压力

Kết quả (Anh) 1:

Press immediately button, adjust the relief valve handwheel slowly, if a filter press plates have been pushing, then the pressure will rise gradually, when rose 25mPa, contact pressure gauge pointer is determined, the motor immediately shut off, when the cylinder pressure is 18mPa,. gauge needle exposure limit, the motor will start by itself, the pressure slowly increases. After repeated calibration, fixed relief valve handwheel, keeping pressure in 18-25MPa between the filter press filtration. have enough top tight when pressure

Kết quả (Anh) 2:

Immediately press the button, slowly adjust the relief valve hand wheel, if the filter plate filter press at this time has been tight top, the pressure will gradually rise, when the rose 25mPa, the contact pressure gauge pointer limit, the motor stops immediately When the fuel tank pressure dropped to 18mPa, press. gauge pointer at the contact limit, the motor will start on its own, the pressure slowly rises. repeated check, the fixed relief valve hand wheels, so the pressure was maintained at 18-25mpa between, so a filter press. When there is enough pressure on the top tight

Kết quả (Anh) 3:

Press the next button, slowly adjust the relief valve handwheel, if this filter press filter plate has been the top tight, then the pressure will rise gradually, when rose to 25mPa, pressure gauge pointer exposure limit when the motor is immediately stopped running, when the cylinder pressure dropped to 18mPa and pressure. Table pointer contact limit, the motor will launch itself, the pressure gradually increased. Repeated check, fixed overflow valve handwheel, let the pressure maintained at between 18-25mpa, enable filter. When there are enough top tight pressure